Behind our production power lies our attention to detail.
In our constantly evolving QC laboratory, we inspect every step of production using modern equipment and our expert team. We continuously raise our own internal standards while not only meeting our customers’ expectations but exceeding them.
It starts with chemical analysis, followed by tensile and Rockwell hardness tests. Approved wire rods are relabeled and transferred to production. From this point on, each step is monitored and recorded in line with our quality control protocols.
Chemical analysis, heat/batch identification and relabeling.
Tensile and Rockwell/Vickers hardness tests per specification.
In-process measurements, SPC checks and nonconformance capture.
Phosphate coating, salt spray, thickness and adhesion tests.
Inline Mectron/optical sorting integration.
End-of-line tests, pack approval and barcode traceability.
Yield strength, ultimate tensile strength and elongation.
Rockwell & Vickers hardness measurements.
Microstructure, grain size and defect analysis.
Thickness (X-ray), adhesion and salt spray corrosion tests.
High-speed optical inspection for zero-defect shipments.
Take a quick tour of our lab and see our equipment in action.
National and international documents that verify our standards.
